zinstall_packages = zcmlloader opencore_site_id = openplans opencore_site_title = OpenPlans email_from_address = support@openplans.org mailing_list_fqdn = lists.openplans.org -Z -f https://svn.openplans.org/eggs/ -f http://dist.repoze.org/PIL-1.1.6.tar.gz PIL -f https://svn.openplans.org/svn/vendor/ClockServer/openplans/#egg=ClockServer-0.1 ClockServer -f https://svn.openplans.org/eggs/twill-0.9.tar.gz#egg=twill -e https://svn.openplans.org/svn/OpenPlansOrg#egg=OpenPlansOrg -e https://svn.openplans.org/svn/opencore/tags/0.12.1 -e https://svn.openplans.org/svn/CabochonClient/trunk@13123#egg=CabochonClient -e https://svn.openplans.org/svn/topp.featurelets/tags/pre-p3-merge -e https://svn.openplans.org/svn/topp.utils/tags/0.5#egg=topp.utils-0.5 -e https://svn.openplans.org/svn/WSSEAuth/trunk@14327#egg=WSSEAuth # In order to use zinstall, we need the package source so we can get # at its setup.py. This is annoying, but I don't know what to do about # it. -e https://svn.openplans.org/svn/ZCMLLoader/trunk@14130#egg=ZCMLLoader -e https://svn.openplans.org/svn/opencore/plugins/oc-vacuum/trunk#egg=oc_vacuum -e https://svn.openplans.org/svn/opencore/plugins/oc-cab/trunk@16578#egg=oc_cab -e https://svn.openplans.org/svn/opencore/plugins/oc-tt/trunk@16819#egg=oc_tt -e https://svn.openplans.org/svn/opencore/plugins/oc-feed/tags/pre-p3-merge#egg=oc_feed -e https://svn.openplans.org/svn/fassembler.configparser/tags/0.2 -f https://svn.openplans.org/svn/vendor/geopy/openplans/dist/geopy-0.93_20071130-py2.4.egg geopy threadframe>=0.2